Using a Ricoh Printer on a Macintosh

From UW-Math Wiki
Revision as of 09:14, 18 October 2011 by Ynagel (talk | contribs) (Hints)
Jump to: navigation, search

Adding the Ricoh Printer to a Mac

There is a Ricoh MFP C4501 copier on floors 3-8 of Van Vleck. Note that in order to print to them your computer should be connected to the Van Vleck network via a wired connection and your username on your computer should be the same as your Math Department username. You can configure your Macintosh to print to these printer/copiers by following the steps below:

  1. Download and install the Ricoh Aficio C4501 driver. Note: you will need to have at least MacOS 10.5.
  2. Set up the printer by clicking on Apple -> System Preferences -> Print and Fax. The display below shows how to

setup the 7th floor Ricoh printer:

    MacPrintSetup.jpg

If you prefer to do this via a command line, do the following (after downloading and installing the driver) (This example sets up the 5th floor printer)

Open a terminal window and type the following commands

  • sudo tcsh
  • (then type an administrator password)
  • lpadmin -E -p 5 -v ipp://printserver2.math.wisc.edu:631/printers/5 -P "/Library/Printers/PPDS/Contents/Resources/RICOH Aficio MP C4501"
  • cupsenable 5
  • cupsaccept 5

Hints

NOTE: if have a personal Macintosh and you would like to print to our copiers you must do the following:

   * connect to our network with a WIRED connection - there are free ethernet connections
     in our two labs.
   * The username (aka short name, Account name) and password on your mac must be the same as your math dept username.

If your local username is different from your username in the Math Department, you can print using a command like this:

   lp -d P -U <yourusername> file.pdf
  (where P is the name of the printer (e.g. 5) and <yourusername> is your username.  
   NOTE that you can only print postscript or PDF files)

OR you can change your short username using these instructions

   http://www.macworld.com/article/132693/2008/03/changeshortusername.html

See the section with this title

   The middle ground: changing just your short username

By default, files will print in B&W. To print in color, do this

   1) save or print the file as a PDF - say  file.pdf
   2) from a terminal window on your mac type
               lp -d N  -o ColorModel=color  file.pdf
               where N=3..8  is the number of your floor